koban KPAW-01 Manuel page 135

KPAW-01
TRUE RMS 1000A AC WATT Clamp Meter
SAVE
SEL
MAXMIN
CLEAR
MR
▼/▲
10
sum up the phase power measurement
result which had been selected.
if you didn`t select any phase of 3
phase, ∑ is invaild.
Press once to store single reading, and
the Meter beeps.The index number shown
on the left secondary display keep on
increasing. The maximum number of data
store is 99, when it achieves 99, the Meter
shows
press SEL button to step through first
phase, second phase, third phase and sum
of watts.
Press SEL and hold for over 2 second
to enter 3P3W mode.
Press to start recording of maxinmum it
valid at voltage, current, active power and
apparent power ranges only.
At active energy range, press CLEAR
and hold for over 1 second to reset time the
zero, then restart the timing.
At all other ranges, press CLEAR and
hold for over 1 second to clear stored
readings.
Press once to enter Memory Record mode,
appears and the Meter beeps.
If the Meter steps through sum of
power press ▼/▲ button to switch
display of active power (main display) ,
sum of reactive power (secondary
display) , sum of power factor (main
display) and sum of apparent power.
.
www.grupotemper.com