koban KPAW-01 Manuel page 139

KPAW-01
TRUE RMS 1000A AC WATT Clamp Meter
Replace the battery as soon as the battery indicator
appears on the display.
Non-Contact Voltage Detector
WARNING: Risk of Electrocution. Before use, always test
1. Rotate the Function switch to any measurement position.
2. Place the detector probe tip on the conductor to be tested.
NOTE: The conductors in electrical cord sets are often
twisted. For best results, move the probe tip along
a length of the cord to assure placing the tip close
to the live conductor.
NOTE: The detector is designed
with high sensitivity. Static
electricity or other sources
of energy may randomly tri
p the sensor. This is norm
al operation.
14
the Voltage Detector on a known live circuit to
verify proper operation.
www.grupotemper.com