Drive V-Belt - Yamaha FX Nytro 2008 Manuel D'atelier

Table des Matières

DRIVE V-BELT

2. Adjust the position of the V-belt by removing or

adding a spacer 1 on each adjusting bolt 2.

V-belt position

More than 1.5 mm

(0.06 in) above the

From 1.5 mm (0.06 in)

above the edge to

–0.5 mm (–0.02 in)

below the edge

More than –0.5 mm

(–0.02 in) below the

• Secondary sheave adjusting bolt 2

Secondary sheave adjusting bolt:

10 Nm (1.0 m · kg, 7.2 ft · lb)

• Drive V-belt

Cracks/damage/wear → Replace.

Oil or grease on the V-belt → Check the pri-

mary and secondary sheaves.

• Primary sheave

• Secondary sheave

Oil or grease on the primary and secondary

sheaves → Use a rag soaked in lacquer thin-

ner or solvent to remove the oil or grease, and

then check the primary and secondary

Remove a spacer

Not necessary

(It is correct.)

0.5 mm (0.02 in)

1.0 mm (0.04 in)

Table des Matières