Yamaha FX Nytro 2008 Manuel D'atelier page 534

1
a
1
a
b
c
d
CRANKSHAFT AND BALANCER SHAFT
2
b
2
3
4
5-76
8. Install:
• Primary sheave drive shaft assembly 1
(to the crankshaft 2)
NOTE:
Align the shallow groove a in the primary drive
shaft assembly with the low spline b of the crank-
shaft.
9. Install:
• Crankshaft 1
(with primary sheave drive shaft assembly)
NOTE:
• Align the punch mark a of the balancer drive
gear 2 on the crankshaft with the punch mark b
of the balancer driven gear 3.
• Align the hole c in the bearing 4 with the projec-
tion d on the upper crankcase.
ENG