Steering System - Yamaha FX Nytro 2008 Manuel D'atelier

2
1
1
LT

STEERING SYSTEM

Toe-out adjustment
1. Place the snowmobile on a level surface.
2. Measure:
3. Adjust:
2
Adjustment steps:
• Remove the shroud.
• Loosen the locknuts (tie-rods) 1.
• Turn the tie rods 2 in or out until the specified
1
LT
• Tighten the locknuts (tie-rods) 1.
After tightening the inside and outside ball joint
locknuts 1, make sure the tie rods 2 can be
rotated freely through the ball joint travel. If not,
loosen the locknuts 1 and reposition the ball
joint so that the tie rods 2 can be rotated freely.
Tighten the locknuts to specification.
2-43
• Ski toe-out (a – c)
• Ski stance b
Point the skis forward.
Out of specification → Adjust.
Ski toe-out:
0 ~ 15 mm (0 ~ 0.59 in)
Ski stance (center to center):
FX10/FX10RT/FX10RTR/FX10RTRA
1,050 mm (41.3 in)
FX10MT/FX10MTR/FX10MTRA
980 mm (38.6 in)
• Ski toe-out
Refer to "COVERS" in CHAPTER 3.
toe-out is obtained.
Tie-rod end locknut:
25 Nm (2.5 m · kg, 18 ft · lb)
®
LOCTITE
CAUTION:
INSP
ADJ