Fuse Inspection - Yamaha FX Nytro 2008 Manuel D'atelier

BATTERY INSPECTION/FUSE INSPECTION
2
7. Install:
• Battery
8. Install:
• Battery bracket
9. Connect:
• Battery leads
1
CAUTION:
First, connect the positive battery lead 1, then
the negative battery lead 2.
10. Check:
• Battery terminals
11. Lubricate:
• Battery terminals

FUSE INSPECTION

The following procedure applies to all of the fuses.
CAUTION:
To avoid a short circuit, always turn the main
switch off when checking or replacing a fuse.
1. Remove:
• Right side cover
2. Inspect:
• Continuity
Inspection steps:
• Connect the pocket tester to the fuse and check
the continuity.
NOTE:
Set the pocket tester selector to "Ω × 1".
• If the pocket tester indicates "∞", replace the
fuse.
2-53
INSP
(to the battery terminals)
Dirt → Clean with a wire brush.
Loose connection → Connect properly.
Recommended lubricant:
Dielectric grease
Refer to "COVERS" in CHAPTER 3.
Pocket tester:
90890-03112
Analog pocket tester:
YU-03112-C
ADJ