Yamaha FX Nytro 2008 Manuel D'atelier page 781

Parts to be tightened
Control rod shaft and sliding frame
Rear axle nut
Set bolt (front axle)
Speed sensor
Bearing holder (front axle)
Bearing housing bolt
Bearing housing bolt
Gear unit (speed sensor) bolt
NOTE:
Tightening steps:
1. Tighten the bolt to a torque at 120 Nm (12.0 m · kg, 85 ft · lb).
2. Loosen the bolt completely.
3. Retighten the bolt to a torque of 60 Nm (6.0 m · kg, 43 ft · lb).
TIGHTENING TORQUE
Tightening torque
Nm m · kg ft · lb
72 7.2 52 (FX10MT/FX10MTR/FX10MTRA)
75 7.5 54
9 0.9 6.5 Apply LOCTITE
24 2.4 17
24 2.4 17
30 3.0 22 Left side
24 2.4 17 Right side
40 4.0 29
9-24
SPEC
Remarks
®