Identification; Handling - Gaspardo PRIMAVERA Emploi Et Entretien

1.4 IDENTIFICATION

Each individual machine has an identification plate (Fig. 1)
indicating the following details:
1) Mark and address of the Manufacturer;
2) Type and model of machine;
3) Unloaded mass, in Kilograms;
4) Mass full load, in Kilograms;
5) Registration of the machine;
6) Year of manufacture;
7) CE mark.
You are advised to note down your data on the form below, along
with the date of purchase (8) and the dealer's name (9).
8) ____________________
9) ____________________
This information must always be quoted whenever assistance
or spare parts are needed.
ATTENTION
Do not remove, tamper with or make the CE mark affixed on
the machine illegible.
Refer to the information provided on the CE mark for the
manufacturer's contact details (e.g. for requesting spare
parts, etc.).
When the machine is demolished, destroy the CE marking.
cod. G19503100
USE AND MAINTENANCE
fig. 1

1.5 HANDLING

If the machine is handled, it must be lifted by hooking onto the
appropriate holes with a suitable winch or crane of sufficient
capacity (Fig. 2). Because of the danger involved, this operation
should be carried out by trained and responsible personnel. The
mass of the machine is on the identification Plate (Fig. 1).
Stretch the rope to keep the machine level. The hook points can
be detected by finding the «hook» symbol (15, Fig. 4).
g
(1)
(2)
(4)
(3)
(5)
(6)
(7)
fig. 2
ENGLISH
41