Hose Installation - Ultraflex UC 128-TS Manuel D'installation Et D'entretien

ULTRAFLEX

3.4 Hose installation

The two fittings mounted on the cylinder body are already oriented and are ready to be used. If for practical
reasons the orientation must be changed, do as follows:
1. loose the locknut (A) by using a 11/16"wrench;
2. orient the fittings according to the requirements;
DANGER
Do not unscrew the fittings more than one turn (360°).
3. tighten again the stop nut with a torque of 20[Nm] (15[lb· ft]) until the washer comes into contact with it.
Screw the hoses on the cylinder fittings with a torque of 20[Nm] (15[lb· ft]) according to the following instructions:
- minimum hose bend radius 250 mm;
- no interference during engine tilting;
- no interference with the transom;
WARNING
An excessive hose bend could result in its internal breaking which
will cause a bad operation of the system. In this case it is necessary to
replace the damaged hose.
HYDRAULIC CYLINDER FOR OUTBOARD ENGINE
Installation and Maintenance Manual
page 15
-
l
A
NO
of 78