Hose Installation - Ultraflex UC 130 Manuel D'installation Et D'entretien

ULTRAFLEX

3.4 Hose installation

PORT ENTRY
(P)
STARBOARD ENTRY
(S)
Screw the hoses on the cylinder fittings with a torque of 20[Nm] (15[lb· ft]) according to the following instructions:
- minimum hose bend radius 250 mm;
- no interference during engine tilting;
- no interference with the transom;
WARNING
An excessive hose bend could result in its internal breaking which
will cause a bad operation of the system. In this case it is necessary
to replace the damaged hose.
HYDRAULIC CYLINDER FOR OUTBOARD ENGINE
Installation and Maintenance Manual
page 15
-
NO
of 83