Dual Steering Station/Dual Cylinder; General Recommendations - Ultraflex UC 130 Manuel D'installation Et D'entretien

ULTRAFLEX
WARNING
For the additional steering station (lower) tank use only the silver non-vent plug (supplied with the "kit OB-
2S"). For the main steering station (upper) tank use only the black vent plug.
- Repeat the procedure at least 3 times to ensure the absence of air in the system.
NOTICE
The purging procedure is the same for dual station, dual motor, single cylinder and tie bar.

3.6.5 Dual steering station/dual cylinder

- Manually unscrew the two bleed valves
on the hydraulic hose fittings and push
the cylinders to one side up to the end
stroke.
- Position the oil bottle near the main
steering station (upper) according to what
is described in paragraph 3.6.1.
WARNING
Wait until the oil reaches the lower tank and
both tanks are filled.
- Follow the same purging procedure
described in paragraph 3.6.2 starting from
the lower station and repeat it for the upper
station.
WARNING
For the additional steering station (lower) tank use only the silver non-vent plug (supplied with the "kit OB-
2S"). For the main steering station (upper) tank use only the black vent plug.
- Repeat the entire procedure at least 4 times to ensure the absence of air in the system.
3.7 General recommendation
WARNING
It is very important to check the absence of air in the system before using the boat! We recommend trying
to manually move the engine towards port and starboard, making sure that there is no movement of the
cylinder body on the main cylinder shaft.
If the cylinder body moves more than 1/6 inches (15mm), there is still air in the system. The air presence in
the system can cause bad responses to the controls and so it can cause damage, injuries or death.
non-vent plug
ATTENZIONE
HYDRAULIC CYLINDER FOR OUTBOARD ENGINE
Installation and Maintenance Manual
black vent
plug
bleed
valves
silver
page 21
- of 83