Installing The Chute Control Rod - Toro Power Max 724 OE Manuel De L'utilisateur

4
Installing the Chute Control
Rod
Parts needed for this procedure:
2 Carriage bolts
2 Locknuts
Procedure
1. Remove the blue rod cap from the chute control rod.
2. Insert the front end of the rod into the opening in
the back of the chute gear cover until it slides into the
chute gear (Figure 10).
1. Short rod
Figure 10
3. Align the holes in the nested ends of the rods and
insert 2 carriage bolts (in the loose parts bag) through
g019005
Figure 9
2. Long chute control rod
g018899
the short rod from the left side of the machine (from
the operating position).
4. Ensure the chute control operates smoothly.
10