Maintenance; Recommended Maintenance Schedule(S); Preparing For Maintenance; Checking The Engine Oil Level - Toro Power Max 724 OE Manuel De L'utilisateur

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 2 hours
After the first 5 hours
Before each use or daily
Every 25 hours
Every 100 hours
Yearly
Yearly or before storage
Important: You can find more information about maintaining and servicing your machine at www.Toro.com.
Important: Refer to your engine operator's manual for additional maintenance procedures. For engine adjustments,
repairs, or warranty service not covered in this manual, contact an Authorized Briggs & Stratton Servicing Dealer.

Preparing for Maintenance

1. Move the machine to a level surface.
2. Stop the engine and wait for all moving parts to stop.
3. Disconnect the spark plug wire. Refer to Replacing
the Spark Plug.

Checking the Engine Oil Level

Service Interval: Before each use or daily—Check the engine
oil level and add oil if necessary.
1. Remove the dipstick, wipe it clean, then fully install
the dipstick.
2. Remove the dipstick and check the oil level (Figure 33).
If the oil level is below the Add mark on the dipstick,
add oil. Refer to Filling the Engine with Oil.
Maintenance Procedure
• Inspect the traction cable and adjust it if necessary.
• Inspect the auger/impeller cable and adjust it if necessary.
• Change the engine oil.
• Check the engine oil level and add oil if necessary.
• Change the engine oil.
• Replace the spark plug.
• Check the skids and the scraper and adjust them if necessary.
• Inspect the traction cable and adjust or replace it if necessary.
• Inspect the auger/impeller cable and adjust or replace it if necessary.
• Check the auger gearbox oil and add oil if necessary.
• Lubricate the hex shaft.
• Check the air pressure in the tires and inflate them to 17–20 psi (116–137 kPa).
• Drain the gasoline and run the engine to dry out the fuel tank and the carburetor at
the end of the season.
• Have an Authorized Service Dealer inspect and replace the traction drive belt and/or
the auger/impeller drive belt, if necessary.
20
g018886
Figure 33