Publicité
Les langues disponibles
Les langues disponibles
until struck by the rotor blades. Always be sure
to keep children and pets away from area of
operation.
POTENTIAL HAZARD
Stones, toys and other foreign objects may
be picked up and thrown by the rotor
blades.
WHAT CAN HAPPEN
Thrown objects can cause serious personal
injury to operator or bystanders.
HOW TO AVOID THE HAZARD
Keep the area to be cleared free of all
objects that could be picked up and thrown
by rotor blades.
Keep all children and pets away from area
of operation.
4.
Should you find it necessary to clear snow from
crushed rock or gravel, push down on handle to
raise rotor blades clear of loose material that
could be thrown by the blades and push unit
forward.
5.
In some snow and cold weather conditions, some
controls and moving parts may freeze solid. DO
NOT USE EXCESSIVE FORCE WHEN
TRYING TO OPERATE FROZEN
CONTROLS. When any control or part
becomes hard to operate, start the engine and let
it run for a few minutes.
6.
AFTER CLEARING SNOW–Let engine run
for a few minutes so ice does not freeze moving
parts solid. After engine is shut off, wipe ice and
snow off entire unit. On models 38422 & 38424,
operate chute crank several times to clear
mechanism of snow.
IMPORTANT: STORE SNOWTHROWER
IN OPERATING POSITION ON ITS
WHEELS. TIPPING OR STORING UNIT
FORWARD ONTO FRONT HOUSING
MAY CAUSE HARD STARTING.
Maintenance
NOTICE:
Maintenance, replacement or repair
of the emission control devices and
systems may be performed by any
nonroad engine repair establishment
or individual. However, to obtain no
charge repairs under the terms and
provisions of the Toro warranty
statement, any service or emission
control part repair or replacement
must be performed by an
Authorized Toro Service Dealer.
Keep snowthrower in safe operating condition by
cleaning the unit and tightening nuts, bolts, and
screws. The scraper, drive belt, rotor blades, and
spark plug should be checked once a year.
Adjusting Control Bar
Periodically check control bar for proper adjustment.
1.
Turn key switch to OFF.
2.
CHECK ADJUSTMENT (Fig. 8 & 10)—Move
control bar back toward handle until slack in
cable is removed. Gap between control bar
bracket and handle should be approximately
1/16"–1/8". If cable is too loose or too tight,
proceed to step 3 for adjustment procedure.
Note:
The control cable must always have
slack in it when in the disengaged
position.
3.
ADJUST CABLE
A. Models 38409 & 38414 – Unhook spring
end from the top hole in control bar bracket
(Fig. 8). Slide spring cover off spring and
cable adjuster. Unhook Z fitting from cable
adjuster and reposition Z fitting in a higher
or lower hole on adjuster to obtain proper
gap of 1/16"–1/8" between control bar
bracket and handle (Fig. 9). (Positioning
cable end in a lower hole decreases gap;
positioning cable end in a higher hole
increases gap.) Reinstall spring cover over
cable adjuster and spring. Rehook spring
into top hole of control bar bracket (Fig. 8).
EN–9
Publicité
Chapitres
