Publicité
Les langues disponibles
Les langues disponibles
4.
STARTING
A. RECOIL STARTING—Hold snowthrower
with one hand and pull recoil starter
vigorously with other hand.
B. ELECTRIC STARTING—Connect
extension cord to snowthrower and standard
household power outlet. Push starter button.
When engine starts, disconnect extension
cord from snowthrower and outlet.
IMPORTANT: Excessive running of the
electric starter could damage the starter due
to overheating. If you are having difficulty
starting the engine, ONLY TRY THIS
STARTING PROCEDURE TWICE. Run the
electric starter no more than 10 times at
intervals of 5 seconds ON, 5 seconds OFF. If
engine does not start after this first attempt,
wait more than 40 minutes to allow starter to
cool before trying to run starter again. Before
repeating engine starting procedure, check
that ignition key switch is ON, and make sure
there is fresh fuel in fuel tank. If engine still
will not start after a second attempt, bring the
snowthrower to an Authorized Toro Service
Dealer for servicing.
5.
When engine starts, push in choke slowly.
6.
TO START/STOP ROTOR—To start rotor,
squeeze control bar to handle. When the control
bar handle is released, the rotor blades stop, but
the engine continues to run.
7.
TO STOP ENGINE—Release control bar to stop
rotor, turn key to OFF, and wait for all moving
parts to stop before leaving operator's position.
EN–8
Operating Tips
1.
ADJUSTING DISCHARGE CHUTE
(Models 38409 & 38414) (Fig. 13)–Move the
chute handle left and right to adjust the direction
of the snow stream. The chute deflector handle
on top of the discharge chute controls the height
of the snow stream. Do not overtighten the chute
deflector mounting nuts so excessive force is
required to adjust the deflector.
IMPORTANT: Do not use chute handle to lift
snowthrower; damage to chute handle could
result.
ADJUSTING DISCHARGE CHUTE
(Models 38422, 38424, 38432 & 38437)
(Fig. 14)–Rotate chute crank clockwise to move
discharge chute to the right and
counterclockwise to move chute to the left. The
chute deflector handle on top of the discharge
chute controls the height of the snow stream. Do
not overtighten the chute deflector mounting
nuts so excessive force is required to adjust the
deflector.
2.
SELF–PROPELLING ACTION–The
snowthrower clears down to the ground and
propels itself forward when the handle is raised
and the snowthrower is tilted slightly forward so
rotor blades strike the ground. The wheels do not
have to touch the ground in order to self-propel.
The further you tilt the handle forward, the faster
the snowthrower self-propels. However, height
and density of snow affects forward speed.
Always overlap each swath and discharge
downwind whenever possible.
3.
Keep the area to be cleared free of stones, toys or
other foreign objects which may be picked up
and thrown by the rotor blades. Such items could
be covered by snowfall and, therefore, unnoticed
Publicité
Chapitres
