Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly
Note:
Determine left and right sides of
snowthrower by standing in the normal
operating position.
Install Wheels (Fig. 2)
1.
Place a wood block under the wheel axle for
support.
2.
Slide a spacer and wheel onto the axle. The side
of the wheel with six spokes must face the center
of the axle. Slide a pushnut onto the end of the
axle.
3.
Using a hammer, strike the pushnut to seat the
nut firmly in place. Repeat steps 2–3 for the
other wheel.
Install Discharge Chute And
Chute Handle (Fig. 3)
1.
Place chute handle over chute ring.
2.
Insert discharge chute between chute ring and
chute handle. Align holes.
3.
Secure back of chute and handle to center hole in
chute ring with a carriage bolt, washer, and
locknut. Position washer and nut on outside of
chute.
Note:
Chute ring may be rotated to ease
assembly of discharge chute.
4.
Secure chute and handle to remaining holes in
chute ring and tighten all nuts securely.
Install Handle (Fig. 4)
1.
Remove tie securing control cable to lower
handle.
2.
Slide handle ends through openings in shroud
and onto lower handles inside shroud.
3.
Secure right side of handle with (2) machine
screws. Secure left side of handle with (1)
machine screw, (1) eyebolt, and a spacer. Use the
eyebolt to mount upper left side of handle. Insert
the eyebolt through the spacer before using it to
secure handle to the snowthrower frame. The
eyebolt must be positioned perpendicular to
handle when tightened.
Install Control Cable (Fig. 5-6)
1.
Route control cable through eyebolt on left side
of snowthrower.
2.
Hook spring to round hole at end of cable
adjuster (Fig. 5).
3.
Route cable through elongated hole in cable
adjuster. Insert Z fitting on end of cable into 3rd
hole on cable adjuster (Fig. 5).
4.
Slide spring cover over spring and cable adjuster.
Push spring end through hole at end of spring
cover.
5.
Hook spring into top hole of control bar bracket
(Fig. 6).
6.
Move control bar back toward handle until slack
in cable is removed. The gap between the control
bar bracket and handle should be approximately
1/16"–1/8". See insert, Figure 6. If an
adjustment is required, refer to Adjusting
Control Bar, page 10.
Note:
The control cable must always have
slack in it when in the disengaged
position.
EN-5
Publicité
Chapitres
Table des Matières
