Installing The Chute - Toro Power Max 724 OE Manuel De L'utilisateur

5. Rotate the lower link arm fully downward (clockwise)
(Figure 6).
Figure 6
6. Push down on the speed control rod and insert the
trunnion into the hole in the speed selector lever
(Figure 5).
Note: If the trunnion does not fit into the hole
when you lift up on the speed control rod, rotate the
trunnion upward or downward on the speed control
rod until it fits.
7. Secure the trunnion and upper end of the speed control
rod with the outer washer and a hairpin cotter you
previously removed.
Note: For easier installation, look down through the
opening in the speed selector (Figure 7).
Figure 7
1. Speed selector
3

Installing the Chute

Parts needed for this procedure:
2 Nut
2 Bolt
Procedure
1. Place the chute on the frame and the align the discharge
chute mount to the chute support.
1
g019013
1. Bolt
2. Secure the discharge chute mount using 2 bolts and
2 nuts.
9
Figure 8
2. Nut
2