Filling The Engine With Oil; Checking The Tire Pressure; Checking The Skids And Scraper - Toro Power Max 724 OE Manuel De L'utilisateur

5

Filling the Engine with Oil

No Parts Required
Procedure
Your machine comes with oil in the engine crankcase.
Note: Before starting the engine, check the oil level and
add oil if necessary.
Use automotive detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher. Refer to your engine owner's
manual.
Use Figure 11 below to select the best oil viscosity for the
outdoor temperature range expected:
g019049
Engine Oil Capacities
Model
37770
1. Remove the dipstick and slowly pour oil into the oil
fill tube to raise the oil level to the Full mark on the
dipstick. Do not overfill. (Figure 12).
Figure 11
Engine Oil Capacity
18 to 20 oz. (0.53 to 0.59 l)
2. Install the dipstick securely.
Note: Do not spill oil around the oil fill tube; oil could
leak onto traction parts and cause the traction to slip.
6

Checking the Tire Pressure

No Parts Required
Procedure
The tires are overinflated at the factory for shipping. Reduce
the pressure equally in both tires to between 17 and 20 psi
(116 and 137 kPa).
7
Checking the Skids and
Scraper
No Parts Required
Procedure
Refer to Checking and Adjusting the Skids and Scraper in
Maintenance.
11
g018886
Figure 12