Adjusting The Discharge Chute Latch; Replacing The Drive Belts - Toro Power Max 724 OE Manuel De L'utilisateur

Figure 45
1. Spark-plug wire
2. Bracket
5. Clean around the base of the spark plug (Figure 45).
6. Remove and discard the old spark plug.
Note: You will need a ratchet wrench extension to
remove the spark plug.
7. Set the gap between the electrodes on a new spark plug
at 0.030 inch (0.76 mm) (Figure 46).
Figure 46
1. 0.030 inch (0.76 mm)
8. Install the new spark plug, tighten it firmly, and attach
the ignition wire to the spark plug.
9. Install the bracket with the thumb screw that you
removed in step 4.
10. Ensure that the primer bulb hose and the ignition wire
are connected and clear of the carburetor bracket.
11. Secure the upper snow hood to the machine with the 2
screws that you previously removed.
12. Align the tab on the choke control knob with the slot
on the upper snow hood.
13. Connect the choke control knob to the choke shaft on
the carburetor.
3. Thumb screw
Adjusting the Discharge Chute
Latch
If the discharge chute does not lock into the desired position
or does not unlock so that you can move it to another
position, adjust the discharge chute latch.
1. Loosen the clamp fastener on the chute support plate
until the cable is free.
1. Cable conduit
2. Cable clamp
2. Remove any slack in the cable by pulling the cable
conduit rearward.
3. Tighten the clamp fastener while holding the cable in
place.

Replacing the Drive Belts

If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, have an
Authorized Service Dealer replace the belt.
25
g019021
Figure 47
3. Clamp fastener
1
2
3