Toro Power Max 724 OE Manuel De L'utilisateur page 28

Problem
Engine runs, but the machine discharges
snow poorly or not at all
Discharge chute either does not lock into
place or does not move
The machine does not properly clear the
snow off the surface
Possible Cause
1. The throttle is not in the Fast position
when throwing snow.
2. The machine is moving too fast to clear
the snow.
3. You are trying to remove too much
snow per swath.
4. You are trying to remove extremely
heavy or wet snow.
5. The discharge chute is plugged.
6. The auger/impeller drive belt is loose
or is off the pulley.
7. The auger/impeller drive belt is worn
or broken.
1. The discharge chute latch is not
properly adjusted.
1. The skids and/or scraper are not
properly adjusted.
2. The pressure in the tires is not equal.
28
Corrective Action
1. Move the throttle to the Fast position.
2. Shift the machine into a lower gear.
3. Reduce the amount of snow removed
per swath.
4. Don't overload the machine with
extremely heavy or wet snow.
5. Unclog the discharge chute.
6. Install and/or adjust the auger/impeller
drive belt; refer to www.Toro.com
for servicing information or take the
machine to an Authorized Service
Dealer.
7. Replace the auger/impeller drive belt;
refer to www.Toro.com for servicing
information or take the machine to an
Authorized Service Dealer.
1. Adjust the discharge chute latch.
1. Adjust the skids and/or the scraper.
2. Check and adjust the pressure in one
or both tires.