Type-Specific Safety And Warning Notices - Burkert 2000 Mode D'emploi

WARNING!
General hazardous situations.
To prevent injuries, ensure that:
▶ The system cannot be activated unintentionally.
▶ Installation and maintenance tasks may be performed by autho-
rised technicians only and with the appropriate tools. Only use
original spare parts.
▶ The process must be restarted in a defined or controlled manner
after an interruption in the power supply or pneumatic supply.
Please observe the following in order to protect against damage
to the device:
▶ When screwing the electrical position feedback indicator in or
out, never use the device socket as a lever, but grasp the screw-
in base of the position feedback indicator.
The actuators and accessories were developed taking into
account the recognized safety regulations and correspond to
the state of the art. Nevertheless, dangerous situations may
occur. Only operate the devices when they are in perfect
condition and in compliance with the operating instructions.
Observe the work instructions, their sequence and the safety
instructions and safety markings when installing the res-
pective components.
6
3.1 Type-specific safety and warning
notices
3.1.1 Safety instructions for actuators 175
and 225 (Ø in mm)
WARNING!
Risk of injury and functional failure due to parts jumping out
or slipping.
The actuators contain preloaded springs that can jump out or slip
if not opened properly.
▶ The actuators Ø 175 mm and 225 mm may only be opened by the
manufacturer.
3.1.2 Note for actuators
50, 63, 80, 100, 125 (Ø in mm)
NOTE!
Damage to the actuators due to wrong tool.
• Only the tools specially offered by Bürkert may be used to screw
on the actuator cover (see chapter "12 Installation accessories").
3.1.3 Note for actuators DN80 125 (Ø in mm)
NOTE!
For the variant of the actuator DN80 Ø 125, operation with
maximum stroke limitation, min./max. Stroke limitation and hand-
wheel not permitted.
English
Type 2000, 2006, 2012
2030, 2031, 2032, 2033
Basicsafetyinstructions