Intended Use; Basic Safety Instructions - Burkert 2000 Mode D'emploi

Type 2000, 2006, 2012
2030, 2031, 2032, 2033
Intendeduse
2 INTENDED USE
▶ The actuators and their accessories may only be used for the
intended applications described in the respective operating
instructions and only in connection with third-party devices and
components recommended or approved by Bürkert. Any other
or additional use is not considered part of the intended use.
▶ Observe the information in these assembly instructions as well
as the conditions of use and permissible data specified in the
operating instructions and on the type label of the components
used.
▶ Proper and safe operation of the devices requires proper trans-
port, storage and installation as well as careful operation and
maintenance.
3 BASIC SAFETY INSTRUCTIONS
These safety instructions do not take account of any
• contingencies or events which may occur during installation, ope-
ration and maintenance of the devices;
• Local safety regulations that are within the operator's scope of
responsibility, including those relating to the installation personnel.
DANGER!
Danger – high pressure.
▶ Before loosening lines and valves, turn off the pressure and vent
the lines.
Danger from electrical voltage.
▶ Before accessing the device or the system , switch off the
power supply and secure it to prevent reactivation!
▶ Observe any applicable accident prevention regulations and
safety regulations for electrical devices.
Risk of injury when unscrewing the transparent cap.
The transparent cap must not be under pressure when
unscrewing it.
▶ When unscrewing the transparent cap, only the lower piston
chamber may be pressurized with compressed air via the lower
pilot air port.
English
5