Attach the generator to the slab at the four corner locations
(B) with masonry anchors as required by local code.
D
C
A
B
A - Standby generator enclosure
A1 - Roof overhang
B - Mounting holes in generator base
B1 - Diagonal measurement of mounting holes
C - Fuel inlet location
D - Wire entry location
E - Exhaust outlet area reference
F - Concrete slab reference
F
A
B
D
C
A1
B1
E
A1
Lifting the Generator
WARNING
could cause electric shock or burns, resulting in death or
serious injury.
• If lifting or hoisting equipment is used, DO NOT
contact any power lines.
• DO NOT lift or move generator without assistance.
• DO NOT lift unit by roof as damage to generator
will occur.
Proper tools, equipment, and qualified personnel should be
used in all phases of handling and moving the generator.
The approximate weight of the generator is listed in the
Generator Specifications Section.
Use the lifting holes (G) in the base of the generator to lift
F
the generator onto the concrete pad. Lift the generator in
accordance with OSHA or local lifting regulations. Retouch
any chipped paint with supplied touch-up paint.
Hazardous Voltage - Contact with power lines
G
13