Installation; Lifting The Generator; Cold Weather Kit; Anchoring And Wind Rating - Briggs & Stratton GC1031 GENSET Mode D'emploi

Installation

This product is only for use as an optional generator system
which provides an alternate source of electric power
and to serve loads such as heating, refrigeration, and
communication systems that, when stopped during any power
outage, can cause discomfort or inconvenience.
Every effort has been made to make sure that the information
in this manual is accurate and current. However, we reserve
the right to change, alter, or otherwise improve the product
and this document at any time without prior notice.
Only current licensed electrical and plumbing professionals
can attempt generator system installations. Installations must
strictly comply with all applicable codes, industry standards,
laws and regulations.

Lifting the Generator

WARNING
Hazardous Voltage - Contact with power lines could
cause electric shock or burns, resulting in death or serious
injury.
• If lifting or hoisting equipment is used, DO NOT contact
any power lines.
• DO NOT lift or move generator without assistance.
Correct tools, equipment, and qualified personnel must be
used in all phases of handling and moving the generator. The
approximate weight of the generator is listed in the Generator
Specifications section.
Use the lifting holes (A) in the base of the generator to lift the
generator onto the concrete slab/pad. Lift the generator in
accordance with OSHA or local lifting regulations.
14

Cold Weather Kit

If the generator operates in temperatures below 30°F (-1°C),
it is HIGHLY RECOMMENDED that a Cold Weather Kit be
installed.
Cold Weather Kit, Part No. 6578 (Fortress models) includes:
• Battery warmer
• Battery stand
Cold Weather Kit, Part No. 6567 (Briggs & Stratton models)
includes:
• Oil warmer
• Battery warmer
• Battery stand
• Wire harness
These items are available at your local service dealer.
If you need more information, please
call 800-732-2989 between 8:00 AM and 5:00 PM CT.

Anchoring and Wind Rating

Concrete Anchoring of Unit to Poured or
Existing Slab
To achieve the listed wind rating, the generator must be
installed in strict compliance with this installation manual.
The product components must be of the material specified
and all screws must be installed in accordance with the
applicable provisions and the anchor manufacturer's
published installation instructions.