Briggs & Stratton GC1031 GENSET Mode D'emploi page 17

Front Panel Removal
1. Remove the two screws (A) that secure the panel to the
unit.
2. If installed (for wind rated regions), remove the two
screws (B) that secure the panel to the base.
3. Lift and flex panel outward and off of the base. Use
caution not to damage the battery box.
Front Panel Installation
1. Lift and flex the panel outward and onto the base. Use
caution not to damage the battery box.
2. With wind rated units, install the two screws at (B).
3. Secure the panel with the two screws at (A).
Install the Roof
1. Carefully put the roof on the unit.
2. Install the screws (A) that secure the roof to the unit.
17