Electrical And Fuel Inlet Locations - Briggs & Stratton GC1031 GENSET Mode D'emploi

The concrete slab/pad must meet the requirements below
and the generator must be anchored with the anchors
of Anchor Types 1 or 2.
Anchor Types
1. Qty (3) 3/8" SS ITW RED HEAD LDT, Anchor embedded
2 ½" (63.5mm) in 3000 psi concrete. 3" (76.2mm) from
the edge minimum, 6" (152.4mm) spacing minimum.
2. Qty (3) 3/8" SS Powers/Dewalt Power Stud +SD2
Anchor embedded 2 ½" (63.5mm) in 3000 psi concrete.
3" (76.2mm) from the edge minimum, 6" (152.4mm)
spacing minimum.
There are three 7/16" hole locations (A) in the base of the
generator in which to anchor the unit.
Concrete Slab/Pad Types
WIND PAD
RATING MODEL
Width
MPH
Up to 140 Pre-cast 29in
Pad (736.6mm)
(contact
dealer)
140 to 175 Pre-cast 29in
Pad (736.6mm)
(contact
dealer)
140 to 175 Poured 30in
(762mm)
These items are available at your local service dealer.
NOTICE Unless mandated by local or state codes to
achieve wind rating, a concrete slab/pad is not required
PAD DIMENSIONS CONCRETE
SPEC
Length Thickness
32in 3in 3000 PSI
(812.8mm) (76.2mm)
32in 4in 3000 PSI
(812.8mm) (101.6mm)
32in 5in 3000 PSI
(812.8mm) (127.6mm)
Panel Attachment in Wind Rated Areas
To achieve a wind rating of 140 mph and above, (2) 1/4-20
Screws (B) are included and must be installed in the bottom
of the front panel.

Electrical and Fuel Inlet Locations

The 3/4 inch N.P.T. fuel inlet connector (A) and electrical inlet
locations (B) are shown below.
A ½ inch knock-out is provided for the electrical inlet. This
inlet can be enlarged or supplemented to accommodate a
maximum conduit size of 1-½ inches. Make sure that the
installed conduit(s) enter the unit in zone (C) as shown in the
drawing that follows so that they correctly enter the electrical
box and do not interfere with the roof or any other component
of the generator.
15