Setting Aside; General Cleaning; Disassembling For Maintenance Or Repair; Residual Risks - MASCHIO GASPARDO PINOCCHIO 130 Mode D'emploi Et Entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 58
ENGLISH

4.0.3 SETTING ASIDE

At the end of the season or if a long period of rest is foreseen, it
is advisable to:
1) Wash the equipment with plenty of water, and then dry it.
2) Carefully check worn or damaged parts and replace if
necessary.
3) Tighten all screws and bolts with the closing coupling mentioned
in the paragraph entitled "Safety maintenance" point 2, page
32.
4) Grease all the points marked by sticker n° 9 ("GREASE") on
page 29 of this manual.
5) Wipe over all the unpainted parts with lubricant.
6) Protect the equipment with a (nylon) cover.
7) Then put it in a dry place, park it where it is out of reach of
unauthorized people.
If these operations are done carefully, it will be to the total
advantage of the user because when work is recommenced, he
will find the equipment in perfect conditions.

4.1 GENERAL CLEANING

Cleaning operations must be carried out periodically in order to
guarantee good machine performance.
To clean the equipment, proceed as follows:
- Park the machine in a suitable place with the side frames open
and resting on the ground;
- Detach it from the tractor;
- Wash it with a water jet, wherever possible from the outside;
- Remove any soil and plant residue using a broom or brush;
- Dry the machinery.
ATTENTION
Do not climb up on the machinery or on the rollers to clean.
4.2 DISASSEMBLING FOR MAINTENANCE OR
REPAIR
During disassembling and re-assembling of the various parts of
the equipment, ensure that the said parts have been assembled
in the correct order (if necessary, mark the various parts during
disassembling).
Please refer to the drawings and photos shown in this manual.
Before disassembling the equipment, be sure to:
- Park the machine in a place that is large enough to allow
obstruction-free disassembling with the side frames open and
resting on the ground;
- Detach the equipment from the tractor;
- Cordon off and suitably mark the operations area;
- Carefully inspect the physical state of the disassembled parts
and replace them if damaged.
ATTENTION
Do not stand underneath suspended loads.
Access to the operations area is forbidden to non authorised
personnel.
Working overalls, safety footwear, gloves and glasses must
be worn.
36
USE AND MAINTENANCE

4.3 RESIDUAL RISKS

The risk caused by pressure oil.
Use the oil that the producer recommended and respect the
provisions existing in the safety chart of the product.
Fire risk.
Do not smoke or use naked flames near the machine: this
could set off a fire in the oil of the hydraulic circuit.
Before making repairs on the machine using arc or flame
welding, ensure that there are no oil leaks from the hydraulic
circuit.
Risk of pollution when draining of oil from the hydraulic circuit.
Used oils must be discharged and disposed of according to
the legislation in force in the country in which the machine
is being used.
Risk of pressurised oil jets being ejected.
The operator must use safety glasses, working overalls, safety
gloves and footwear to ensure that any oil splashes not to
injure eyes, face or uncovered body parts.
Erroneous connection of the machine's hydraulic piping with
the tractor's hydraulic circuit could cause damage to the
machine and potential danger for the operator.
Risk of cutting and blows during cleaning, adjusting and
maintenance of the machine.
The moving parts (anchors, spiked rollers, soil-breaking
discs) represent a potential injury risk for the operator. Use
appropriate PPEs.
Risk when transporting the equipment by road.
The transportation of the equipment by road at night or in
conditions of poor visibility without the appropriate lighting
devices is strictly prohibited as it could lead to accidents.
The risk that lateral rollers may fall during the road
transportation. If these rollers are not raised and fixed, as
indicated in paragraph 3.5.6 of the manual, they may fall during
road transportation, causing a possible break of the equipment
or causing the injury of a third-party person.
ATTENTION
ATTENTION
ATTENTION
ATTENTION
ATTENTION
ATTENTION
ATTENTION
ATTENTION
cod. F07011399

Publicité

Table des Matières
loading

Table des Matières