Before Starting Work; During Work - MASCHIO GASPARDO PINOCCHIO 130 Mode D'emploi Et Entretien

ENGLISH
ATTENTION
The demounting of the axes that hold the mobile elements can
cause the falling of the posterior rollers, and there is the risk
of crushing or perforation the operator's legs.
3.5.6 CLOD BREAKER
Thanks to this accessory, the soil explosion is kept under control
through a series of adjustment holes (Fig. 15).
The metal tangs are fitted directly onto the anchor in their particular
hole.
3.5.7 SIDE SHIELDS (OPTIONAL)
This accessory is applied to the side of the equipment and ensures
that the clods of earth and kept within the area, preventing them
from falling onto the cultivated part or the part still to be worked
Before transiting on the road, withdraw the flaps within the bounds
of the machine and block them into place using the bolts, as shown
in Pos. 1 Fig 16.
Danger of cutting hands while working and handling the
equipment.

3.6 BEFORE STARTING WORK

Before starting any operations grease all parts indicated by transfer
nr. 9 ('GREASE') at page 27 of this leaflet.

3.7 DURING WORK

Always respect the following rules for successful sowing:
- Keep the hydraulic hoist in the position that allows the
equipment to work parallel to the ground.
- Every now and then check that the screws are tight enough;
in particular, tighten the nuts of the vehicle wheels. For new
machines or after repair, tighten all the screws after the first
10 ha.
- Check the safety of the tensioner bolts for integrity and
damage. Check the safety pins (integrity, damage) and
replace them if necessary.
- Check for possible defects in the pins of the upper and lower
arm and of the chains with split pins.
- Check the condition of the bearings and the gaskets:
damage and wound-round material (metal wires, wires, plant
residues, etc.) should be eliminated immediately.
- Check the integrity of the bearings.
- Check that the locking device for transport is working
properly.
- Check the tightness of the hydraulic system, and replace
defective hoses immediately; use only original spare parts.
- Keep the warning stickers on the machine in legible
condition.
- The use of non - original or stronger pins may lead to serious
damage to the equipment.
- Lower the machine when the tractor is in forward gear, to avoid
clogging or damage to the tines; for the same reason the tractor
should not reverse when the machine is on the ground.
- Maintain a work speed compatible with the type of soil and tilling
in order to avoid breakages or damage.
34
USE AND MAINTENANCE
CAUTION
CAUTION
1
fig. 16
Fig. 15
cod. F07011399