Broom Rotation Or Replacement - Nilfisk Hydro-Retriever 2052 Mode D'emploi

BROOM ROTATION OR REPLACEMENT

WARNING!
Shut off broom before entering this area. Do not work in this area with engine running.
Every 50 hours, clean debris from inside the broom housing. Remove any string wrapped around the broom, broom drive hub or idler hub. Check the bristle length on
the broom, replace the broom when the bristles are worn to a length of 4.4 cm. Rotate the broom every 100 hours.
To Rotate or Replace the Broom...
1 Open the Outer Access Door (13) and the Inner Access Door (15).
2 Remove the two Idler Arm Bolts (A) and pull the Idler Arm (B) away from the broom. Slide the broom out of the broom housing.
3 Rotate the broom or install a new broom, following the instructions in reverse order.
FORM NO. 56041606 - Hydro-Retriever
ENGLISH / A-15
2052 / CR 1300 - A-15
™