Adjustment Of The Handlebar Position - Beta Motorcycles RR 350 EFI 2019 Mode D'emploi

3
5
EN
40Nm
6
25Nm
1
25Nm
To adjust the position of the u-bolt remove
the screws shown in the figure.
Remove the handlebar.
Remove the screws 5.
NOTE: Before removing the screws 5 heat
the area with a hairdryer of the type used
by coachbuilders.
Position the U-bolt as required.
At the end refit the screws 5 after the ap-
plication of thread lock fluid and tighten
to the torque indicated.
Apply the handlebar.
Apply the top u-bolt.
Refit the screws 6. Tighten to the torque
indicated.
ADJUSTMENT OF THE
HANDLEBAR POSITION
The handlebar can be adjusted by rotating
it back and forth.
To adjust the handlebar loosen screws 1.
Position the handlebar according to re-
quirements.
Tighten to the torque indicated.
38