Beta Motorcycles RR 350 EFI 2019 Mode D'emploi page 132

4
1
2
EN
REPLACEMENT
Keep the vehicle in vertical position relative
to the ground.
Replacement of the coolant must take place
when the engine is cold.
- Remove the engine casing by loosening
the screws shown in the figure.
- Unscrew cap 1.
- Place a container under screw 2.
- Unscrew the screw 2.
- Drain the liquid.
- Tighten screw 2 applying the specific
washer.
- Re-assemble the engine protection plate
by tightening the screws to 10Nm.
48