Fork; Front Wheel - Beta Motorcycles RR 350 EFI 2019 Mode D'emploi

FORK

To maintenance refer at an authorized
service centre Betamotor.
To check the tightening torques see as
shown in the figure.
WARNING:
Tightening of the screws should be
carried out by adjusting the torque
wrench to the stability torque with
repeated tightening until stability
torque has been achieved.

FRONT WHEEL

TIGHTENING
Following removal of the wheel:
Compress and release the fork 3-4 times.
Tighten the wheel bolt and the screws of
the foot-legs.
WARNING:
Tightening of the screws should be
carried out by adjusting the torque
wrench to the stability torque with
repeated tightening until stability
torque has been achieved.
17Nm
12Nm
61
50Nm
10Nm
4
EN