Adjusting Fork; Adjusting The Compression Damper - Beta Motorcycles RR 350 EFI 2019 Mode D'emploi

3

ADJUSTING FORK

A
ADJUSTING THE REBOUND
DAMPER
The hydraulic rebound damper determines
the behaviour of the telescopic fork during
extension and can be adjusted by means
of knob A. Turning the screw clockwise
(towards +) increases the action of the
rebound damper; turning it anticlockwise
(towards -) decreases the action of the
rebound damper.
For standard calibration, refer to page
11.
ADJUSTING THE SPRING PRELOAD
The spring preload is adjusted by using the
ring nut B. Rotate clockwise to increase
the spring preload or anticlockwise to
decrease it.
The spring preload varies by one millim- B
eter, each complete revolution.
For standard calibration, refer to page
11.
ADJUSTING THE COMPRESSION
DAMPER
The hydraulic compression damper deter-
mines the behaviour of the telescopic fork
during compression and can be adjusted
by means of knob C located at the lower
end of the fork legs. Turning the screw C
clockwise (towards +) increases the ac-
tion of the compression damper; turning
it anticlockwise (towards -) decreases the
action of the compression damper.
For standard calibration, refer to page
11.
EN
39