Gearbox Oil - Beta Motorcycles RR 350 EFI 2019 Mode D'emploi

4
2
2
EN

GEARBOX OIL

CHECK THE LEVEL
1
Hold the vehicle upright.
Position the drive on a flat base ensuring
stability.
Remove the inspection cap 1.
The oil level must arrive to the lower edge
of check hole.
In contrary case restore the oil level through
cap 2.
The inspection cap is ONLY to check
the oil level. For the oil drain, refer to the
paragaraph Replacement, page 46.
Use the oil indicated on page 13 in
the "Recommended lubricants and liquids"
table.
REPLACEMENT
Always perform the replacement when
engine is hot:
- Position the drive on a flat base ensuring
- Remove the engine casing by loosening
- Place a container under the engine.
- Unscrew filler plug 2 and drain plug 3.
- Drain all the oil from the crankcase.
- Apply the cap 3 and tighten up to the
Pour in the quantity of liquid indicated on
page 10.
3
20Nm
Use the oil indicated on page 13 in
the "Recommended lubricants and liquids"
table.
46
stability.
the screws shown in the figure.
WARNING:
Hot oil can cause severe burns!
specified torque.