SciCan HYDRIM L110w G4 Manuel De L'utilisateur page 37

6. Care and Maintenance
Tests to be performed by the user:
Door lock check
This test is to ensure that the door cannot be opened while a cycle is running or a cycle
will not start with the door open. To check that these features are working correctly,
attempt to open the door using the handle immediately after a cycle has started. Caution
– DO NOT attempt this when the wash arms are rotating and/or the water is above
ambient temperature. The door should not open. When you attempt to start a cycle with
the door open, the cycle should not start. If the unit fails this test, stop using it immediately
and call your dealer for technical service.
Wash arm rotation check
Run a P1 cycle and check that wash arms are rotating. If wash arms are not rotating,
remove, visually check and clean as described in Section 6.4.
Door seal check
Visually check the door seal for debris or wear. If the seal is worn or damaged, call your
dealer for technical service.
Load carrier check
Visually check load carriers (trolleys) for wear and tear, damage and that the runners
move freely over their full range.
Chamber filter check
Remove, visually check and clean as described in section 6.4.
Load check
Visually inspect each load for residual soil. Washers are designed to ensure that the
surfaces of instruments are free from debris that may compromise the sterilization process.
A visual check of the instruments processed in each load should be undertaken prior to
sterilization to ensure that no residual debris is present on the instrument.
If debris is still apparent, the instrument should not be considered clean and should be
reprocessed through the HYDRIM again prior to sterilization.
Note: Some set-able materials such as cements, amalgam, and composites, if set on
the instrument will not be removed in a HYDRIM. If these materials are noticed on the
instrument then abrasive removal may be required.
35