Additional User; And Setup Menu Functions - SciCan HYDRIM L110w G4 Manuel De L'utilisateur

5. Instructions for Use
5.27 Additional user and setup menu functions
To access the user or setup menus, follow these steps:
OR
Chamber cleaning
This cycle is used to periodically remove hardwater deposits from
the chamber walls and racks. Pour 1.0 litres (0.26 gal) of vinegar into
the chamber before starting the cycle. Touch "cleaning." A cleaning
cycle, similar to a normal wash cycle, will run. Failure to clean
chamber can promote corrosion.
Set drying time
The drying times for P2 and P3 can be set independently. Touch
the cycle for which you want to set the drying time. Use the up and
down arrows to select the desired drying time. Touch "default" if you
wish to return to the factory default. Use the back arrow to return to
the previous screen.
Set wash time
The wash time for P2 and P3 can be set independently. P2 and P3
cycles can be adjusted from 5 to 15 minutes. Touch the cycle for
which you want to set the wash time. Use the up and down arrows
to select the desired wash time. Touch "default" if you wish to return
to the factory default. Use the back arrow to return to the previous
screen.
Cycle count
This allows the user to see how many cycles have been run on
the HYDRIM. Touch cycle count and the number of cycles
(completed and aborted) will be displayed. This cannot be reset.
Touch the back arrow to return to the previous menu.
Instructions
Users can access a database of pictorial instructions on how to
perform routine maintenance such as installing the cleaning solution.
25