Setting Up Process Enforced Usage - SciCan HYDRIM L110w G4 Manuel De L'utilisateur

5. Instructions for Use
5.21 Creating a User PIN
From the User PIN screen, you can assign up to four PINs. To assign a PIN, follow these
steps:
1.
2.
Scroll to
3.
To assign a user PIN, select
a number (up to 4 digits) and select
screen.
5.
If all of the information presented in the confirmation screen is correct, press OK
to be returned to the User PIN screen. To make a correction, select the User PIN you
want to change and repeat the process described above.

5.22 Setting up process enforced usage

When process enforced usage is activated, users are required to enter a PIN at the end of
a cycle. For process enforced usage to function, User IDs and PINs must first be assigned.
To set up User ID and PINs, refer to sections 5.19 and 5.20 on creating a user name and
PIN. To activate process enforced usage, follow these steps:
1.
2.
Scroll to
3.
Use
to save your selection and return to the Setup menu.
NOTE: Any user can stop a cycle even
with process enforced usage ON.
However, the cycle data will record
that an unauthorized user has stopped
the cycle.
User and select.
User PIN
Process Enforced and select.
to toggle process enforced function ON or OFF. Press
and use the numeric keypad to enter
to save and to move to the confirmation
EN
21