Interrupting / Aborting A Cycle - SciCan HYDRIM L110w G4 Manuel De L'utilisateur

5. Instructions for Use
7. The cycle will begin.
8
8. The cycle is complete.
9

5.26 Interrupting / aborting a cycle

NOTE: If the drying phase of the cycle is interrupted, the critical parts of the cycle are
complete and the message displaying the program name and "Cycle Complete. Drying
interrupted" will appear.
The cycle will start by draining the unit. The bar on the screen
indicates the progression of the cycle. The stage within the cycle
is shown beneath the bar (e.g. Filling, Rinsing). The estimated time
remaining (in minutes) is always displayed. Please note that the
time will increase or decrease depending on the projected cycle
completion.
When the cycle is complete, the program name and "Cycle
Complete" is displayed, and the unit beeps three times. Press "OK"
to open the door. Use gloves to unload the instruments. After all
cycles, exercise caution as the instruments, trolley, baskets and
cassettes may be hot. Inspect the instruments for debris prior to
packaging / sterilizing.
The door of the HYDRIM is locked during the cycle. If the STOP
button is pressed, the cycle is aborted and cannot be re-started.
The message "Draining. Please wait" will appear. The unit will drain.
Then the message "Instruments not processed" will appear. Press
OK. Open the door by pressing
instruments. Exercise caution as instruments, trolley, baskets and
cassettes may be hot. The cycle must be repeated to ensure that
instruments are properly processed.
24
. Use gloves if handling the