Water Hardness; Water Softener - FAR LVSL9C47MI17W Manuel D'utilisation

ENGLISH
intended to optimise and customise the level of
salt consumption.
Please follow the steps below for adjustment in
salt consumption.
1. Switch on the appliance;
2. Press the Start/Pause button for more than 5
seconds to start the water softener set model
within 60seconds after the appliance was
switched on;
3. Press the Start/Pause button to select
the proper set according to your local
environment, the sets will change in the
following sequence: H1->H2->H3->H4-
>H5->H6;
4. Press the On/Off button to end the set up
model.

WATER HARDNESS

°dH °fH °Clarke mmol/l
0~5 0~9 0~6 0~0.94
6-11 10-20 7-14 1.0-2.0
12-17 21-30 15-21 2.1-3.0
GB-14
Salt
Selector Posi- consump-
tion tion (gram/
cycle)
H1-Rapid light
0
bright
H2-90min light
9
bright
H3-
Rapid&90min 12
lights bright
18-22 31-40 22-28 3.1-4.0
23-34 41-60 29-42 4.1-6.0
35-55 61-98 43-69 6.1-9.8
Note1:
1 dH=1.25 Clarke=1.78 fH=0.178mmol/l
dH: German degree
fH: French degree
Clark: British degree
Note2:
The manufactory setting: H3 (EN 50242)
Contact your local water board for information
on the hardness of your water supply.
NOTE: If your model does not have any
water softener, you may skip this section.

WATER SOFTENER

The hardness of the water varies from place to
place. If hard water is used in the dishwasher,
deposits will form on the dishes and utensils.
The appliance is equipped with a special softener
that uses a salt container specifically designed to
eliminate lime and minerals from the water.
ENGLISH
H4-ECO light
20
bright
H5-ECO&Rapid
30
lights bright
H6-ECO&90min
60
lights bright
GB-15