Cleaning The Surfaces; Cleaning The Ash Drawer And Fire Grate; Cleaning The Ash Compartment; Inspecting/Cleaning The Firebricks - HASE LIMAiQ Mode D'emploi

7.3.2 Cleaning the surfaces

HASE stoves are coated with a heat-resistant open pore lacquer that provides
only limited corrosion protection; accordingly, a rust film may develop in
some cases.
Depending on your model, your stove is steel, ceramic or soapstone
cladded.
Ceramic/soapstone:
► Clean the surfaces with a slightly damp cloth.
Steel:
► Use a dry or slightly damp cloth.
► Do not use acidic cleaning agents
(e.g. citrus or vinegar cleaner).
INFO: STEEL CLADDING
Treat areas covered in a rust film with the original HASE Stove Lacquer Spray.
Be sure and follow the instructions on the spray can. Your authorised HASE
dealer carries the stove lacquer spray and can give you tips on using it.
7.3.3 Cleaning the ash drawer and fire grate
► Open the firebox door.
► Sweep the ash through the openings in the fire grate and into
the ash drawer or vacuum the ash.
► Close the firebox door
► Open the service door.
► Pull the ash drawer out of the opening by the cover (Fig. 20).
Empty the ashes into a fireproof container or vacuum out the
drawer.
► Slide the ash drawer back into the opening (Fig. 21).
9 Close the service door.

7.3.4 Cleaning the ash compartment

► Open the service door.
► Pull the ash drawer out of the opening by the cover (Fig. 20).
► Vacuum or sweep out the ash compartment.
► Clean with a dry cloth. Do not use acidic cleaning agents
(e.g. citrus or vinegar cleaner) or water to prevent damaging the
electronics.
► Slide the ash drawer back into the opening (Fig. 21).
9 Close the service door.
7.3.5 Inspecting/cleaning the firebricks
► Open the firebox door
► Verify the firebricks are intact.
If pieces have broken off, the cladding must be
replaced (see chapter "7.3.12 Replacing the firebox
cladding (firebricks)."
► Small cracks do not affect the functionality of your stove.
► Do not use sharp objects to avoid damaging the cladding.
► Sweep or vacuum up the combustion residues.
► Verify the vents in the back panel (Fig. 18) are clear.
Vacuum the openings.
9 Close the firebox door.
7.3.6 Replacing the firebox door seal
108
To replace the seal:
► Open the firebox door.
► Pull the old seal out of the rail starting at one end
and dispose of it in the waste (Fig. 23).
► Wrap approx. 3 cm of one end of the new seal with copper tape
(Fig. 24).
► When installing the seal, ensure it does not sag and is slightly
compressed (Fig. 25).
► Start installing the seal at the middle of the rail at the top
of the firebox door.
Push the seal evenly into the rail (Fig. 26). Allow the end
to protrude slightly and cut off the seal flush (Fig. 27).
► Also wrap this end in copper tape (Fig. 28) and push the seal
into the rail (Figure 24)
9 Close the firebox door.
Fig. 23
Fig. 24
Fig. 25