Adding Fuel / Heating At Nominal; Thermal Output; Heating With Brown Coal Briquettes; Banking The Fire And Raising The Temperature - HASE Como Manuel D'utilisation

7. Adding Fuel / Heating at Nominal

Thermal Output

More fuel should be added to the fire when the
flames from the previous burning off phase have
just gone out.
Adding Fuel / Heating at Nominal Output
Procedure Position of
Control Elements
Adjust primary and Close primary air slider
secondary air. (I), set secondary air
slider (II) between posi-
tion 2 and 3. (fig. 4)
Close fire grate. Push in fire grate slider.
Add two logs weighing
approx. 1,7 kg in total.
Place logs with one end
to the front of fire box.
Only add a single layer
of fuel.
Tab. 2
fig. 4
All manuals and user guides at all-guides.com

8. Heating with Brown Coal Briquettes

Wood should be used for the warming-up phase
and when adding fuel for the first time, see "Warm-
ing-up Phase". As soon as a basic glowing firebed
is reached, place 2-3 brown coal briquettes on the
grate in the middle of the firebox, keeping a finger's
width between the briquettes, and use the following
procedure and settings:
Heating with Brown Coal Briquettes
Procedure Position of
Control Elements
Open primary air com- Pull primary air slider all
pletely. the way out (fig. 5)
Adjust secondary air. Set secondary air slider
to position 2. (fig. 5)
Place 2 briquettes onto
the grate.
Open fire grate. Pull out fire grate slider.
Tab. 3
fig. 5
9. Banking the Fire and Raising the
Temperature
Keep the stove set as described above until the
brown coal briquettes are thoroughly burnt. Then
close the primary air (I) and the fire grate. Slide the
secondary air slider (II) to position 2/3.
CAUTION!
While the stove is in operation, the sec-
ondary air slider should never be com-
pletely closed.
To raise the temperature of the fire, stir up the rest
of the glowing embers with the fire grate slider.
Open the primary air (I) and add new logs to the
fire.
35