Adding Fuel / Heating At Nominal Thermal Output; Heating At Low Thermal Output (During Transitional Seasons); Emptying The Ash Drawer - HASE Sendai Manuel D'utilisation

8. Adding Fuel / Heating at Nominal
Thermal Output
More fuel should be added to the fire when the
flames from the previous burning off phase have
just gone out.
Adding Fuel / Heating at Nominal Output
Procedure
Adjust the combustion air.
Close fire grate.
Add two logs weighing
approx. 1.5 kg total, place
them crosswise with the
ends facing the front of
fire box. Only add one
layer of fuel.
Tab. 2
CAUTION!
Please ensure that the logs are inserted
with sufficient distance (at least 5 cm)
from the furnace window.
44
All manuals and user guides at all-guides.com
9. Heating at Low Thermal Output
(during Transitional Seasons)
You can vary the thermal output of your Sendai by
adjusting the quantity of fuel used.
Position of
Control Elements
Set air slider on posi-
tion 2.

10. Emptying the Ash Drawer

As a safety precaution, please make sure that you
only dispose of ashes once they are cold. While the
ash collects during the fire, the lid (fig. 4/1) is lo-
Push in fire grate slider.
cated under the ash drawer (fig. 4/2).
The ash drawer contains the mineral components
of the wood (approx. 1%) as combustion residues.
Remove both the ash drawer and the lid located
underneath it. Make sure the ash does not pile up
all the way to the bottom of the fire box. Slide the
lid onto the ash drawer so that it is closed; this
prevents ashes from flying around, which in turn
means your home stays clean (fig. 5)
Please ensure that, when inserting the ash drawer,
the ash drawer lid is positioned on the base of the
drawer with the side brackets facing down.
NOTE!
Do not attempt to slow down the com-
bustion by reducing the air supply. When
heating with wood, this can result in an
incomplete burning process and pose the
risk of an explosive like combustion of the
accumulated wood gases (deflagration).
fig. 4
fig. 5
2
1
1
2