Scheppach 19013 04901 Traduction Des Instructions D'origine page 24

Fig. "N"
Fig. "O"
Fig. "P"
24 english
Crosscut 1 mitre gauge
Fig. "N"
Screw the swivelling part and the sliding rail together.
1 washer
1 lock lever
Mount the stop rail onto the swivelling part
2 oval head screws
2 wing-nuts
Set the crosscut / mitre gauge as required to the right or left of
the sawblade.
Locking at 0° and 45° is effected with the socket pin and lock
lever.
table length extension
Fig. "O"
Attach table lenght extension to the machine. Bolt the screws
to the machine only by hand.
11 hexagonal screws
16 washers
5 hexagonal nut
Adjust the table length extension to the saw table flat (with two
wood lathes) and fix all screws.
Fit the hose holder and attach the suction hose Ø 50.
Your Circular saw bench Precisa 6.0 is now fully assembled.
Installing and adjusting
Fig. "P"
Make sure that your scheppach Circular saw bench ts 4020 is
installed so that it is level and stable on a solid surface. Level
out surface uneveness.
To this end at the adjustable feet
• Release the hex. nut (1)
• Carry out the height adjustment
• Tighten up (1) the hex. nut
Ø 6,4
M 6
M 6 x 25
M 6
M8x16
Ø8
M8