Scheppach 19013 04901 Traduction Des Instructions D'origine page 22

Fig. "H"
Fig. "I"
Fig. "J"
Fig. "K"
1
22 english
Push-stick
Fig. "H"
Secure the 2 holding brackets on the long stop.
each with
1 oval head screw
Insert the push-stick into the holding brackets.
When cutting narrow workpieces lengthwise (i.e. smaller than
120 mm) it is essential to use the push-stick).
Parallel fence
Fig. "I"
Adjusting the reading microscope
Adjust the fence against the saw blade and clamp the
eccentric levers (1 + 2). Release the fastening screws of the
reading magnifier; position the hairline precisely over the Zero
line of the scale. Retighten the fastening screwa.
Fig. "J"
Fine-adjustmen
Fine adjustment is with the adjusting spindle (3) while the
eccentric lever (1) is locked, and the eccentric lever (2) is
open.
Suction hood
Fig. "K"
Screw the saucer-head screw M 6 X 40 with washer and lock
lever into the suc- tion hood. Clamp the suction hood securely
on the riving knife.
2
Suction hood „1" without scorer
Suction hood „2" with scorer
IMPORTANT!
The suction hood must be lowered onto the workpiece
for each new job.
B 4,2 x 9,5