Nice MhouseKit WG2W Instructions Et Avertissements Pour L'installation Et L'utilisation page 31

3 slow flashes
5 slow flashes
P3 LED
Off
On
1 flash per second
2 flashes per second
P4 LED
Off *
On
1 slow flash
2 slow flashes
BUZZER
Short beep + long beep at
the end of the manoeuvre
Short beep
Short beep
Short beep + long beep
Short beep
Prolonged 6 second beep
* or it could be in "Standby" mode
Memorisation OK
Cancellation OK
Status
All OK
All OK
The device recognition phase has not been
carried out, or there are errors in the data
saved
Devices recognition phase in progress
Status
All OK
All OK
There is no memorised opening angle
Opening angles recognition phase in progress
Status
The automation has just completed a manoeu-
vre or test phase
During wireless devices installation phase.
The control unit has learned the new wireless
device
Indication resulting from battery insertion into
an accessory device, when the automation is
stopped. The battery has been inserted into a
wireless device known to the network and the
control unit has recognised it
Indication resulting from battery insertion into
an accessory device, when the automation is
stopped. The battery has been inserted into a
wireless device known to the network and the
control unit has recognised it but is indicat-
ing that its battery is empty
A device has been deleted from the network
The procedure described in paragraph 10.3.5
is active, within which you can confirm deletion
of a wireless network present in the network
Memorisation completed successfully
Deletion of all transmitters completed successfully
Action
"Slow" speed selected
"Fast" speed selected
It is possible that there are faulty devices. Check and if neces-
sary repeat the device recognition phase (see paragraph 10.3.3
"Adding further devices to an existing system")
Indicates that it is in the process of recognising the attached
devices (this will take a maximum of a few seconds)
Action
Cycle operation
Complete cycle operation
Carry out the recognition phase (see Chapter 3.5.2 - Leaf open
and closure angles recognition)
Indicates that the open angles self-learning phase is in progress
Action
Check led P1
Normal operation
Normal operation
Check the charge of the newly inserted battery
Normal operation
English – 29