Battery Charge Indicator; Display Height Limit; Operating Modes; Individual Operation - Blitz HydroLift S3 2–6.2-DC Mode D'emploi

HydroLift
Operation

10.2.2 Battery charge indicator

Colour
Green
Yellow
Red

10.2.3 Display height limit

Yellow: a limit is set.

10.3 Operating modes

10.3.1 Individual operation

The control commands always apply to the lifting unit on which the control buttons are
pressed. This operating mode is active after switching on the power supply.

10.3.2 Set-up mode

The set-up of the lifting units takes place in individual operation. The control commands always apply
to the individual lifting unit. The wheel is raised slightly, and then the lift unit is assigned a position on
the control panel with key [10]. The lifting unit is thus registered for group operation. This procedure
should be repeated for all lifting units.

10.3.3 Group holding

Group holding is used to lift a vehicle with several lifting units. It is activated by pressing the
key [3]. In this operating mode, the control commands apply to all lifting units in the group.
The motion commands can come from any group lifting unit

10.4 Before use

Before each use, the batteries of all lifting units must be charged. (→10.9)
96
Meaning
(100%) Batteries are fully charged.
Batteries are partially discharged.
(40%)
(Battery has to be charged →10.9)
Batteries are almost completely
discharged. (Do not conduct any lifting,
(0%)
as this will damage the battery,
lowering is still possible).
100% 40% 0%
126746