Blitz HydroLift S3 2–6.2-DC Mode D'emploi page 117

HydroLift
Error messages
E12 Battery voltage critical
CL Loss of communication
CLE10 Loss of communication
Other possible errors
Error
Keys do not respond
Display does not
respond
Lift is slow
Lifting unit moves
downwards
114
Further operation will result
in deep discharge.
Communication between
individual lifting units
interrupted during
operation.
Communication loss
between motherboard and
input board.
Possible causes
Input board defective.
Cable connections defective.
Cable connections defective.
Overloaded
Batteries defective
Dirt in the hydraulic system.
Oil level too low.
Dirt in the hydraulic system.
Solenoid valve defective.
Check batteries and replace
if necessary.
Check voltage supply of all
lifting units.
Check fuses.
Check the charge level of
the batteries.
Check plug connector inside
the controller.
Check plug connectors.
Troubleshooting Steps
Replace input board.
Replace cable connections.
Check cable connections of the
display.
Check vehicle weight.
Check battery, check connection of
pole terminals.
Check / change oil.
Top up oil.
Change oil.
Replace solenoid valve.
126746