Set Transmission Channel - Blitz HydroLift S3 2–6.2-DC Mode D'emploi

HydroLift
Operation

10.6 Set transmission channel

◼
◼
◼
◼
The transmission channels are assigned the following frequencies
Transmitting
channel
Frequency
Set transmission channel
1. Activate change mode with key 4.
2. Use buttons 2 and 3 to select a new transmission channel.
3. Confirm with key 4.
In single mode, the transmission channel is shown in the display.
102
Each lifting unit can transmit on 36 different frequencies.
If there are several lifting systems in a hall, each
system must be set to its own transmission frequency.
All lifting units of a system must in turn be set to the
same transmission frequency.
If another radio system transmits on the same
frequency, faults may occur (error message CL or E1). Here you have to
change the transmitting channel.
S1 S2
2410 MHz 2415 MHz
S3 S4
2420 MHz 2425 MHz
[2] [3] [4]
.............
S36
.............
2935 MHz
126746