Change System Grouping - Blitz HydroLift S3 2–6.2-DC Mode D'emploi

10.7 Change system grouping

This allows height correction on a single wheel or on a vehicle axle without disintegrating the
group. Press key (1) 3 times to return to the initial state.
Press once:
The lifting unit on which the key is pressed, will be active.
The lifting unit is in single mode.
Press twice:
Both lifting units of the same vehicle axle are active.
They raise and lower together.
Press 3 times:
The initial grouping is restored.
126746
DANGER
Risk of death and injury when using safety stands
◼
Always perform this function under the supervision of a qualified person.
HydroLift
Operation
1
103