Setting Up The Lifting System - Blitz HydroLift S3 2–6.2-DC Mode D'emploi

10.5 Setting up the lifting system

◼
◼
◼
◼
◼
◼
126746
DANGER
Risk of death and injury due to incorrect operation
◼
Only use lifting equipment on level and stable ground.
◼
Always push the lifting unit.
◼
Always observe the route.
◼
Always move the lifting units slowly.
Information about the axle loads can be found in the documentation of the
manufacturer. If in doubt, determine the axle loads on a scale.
For trailing and steering axles special conditions apply. Overload may occur.
In this case, ask the vehicle manufacturer before lifting whether this is
permissible.
The use of more than 4 lifting units can lead to uneven load distribution. It is
the responsibility of the operator not to overload individual lifting units. If
necessary, consult a specialist.
Before releasing the handbrake, secure the vehicle with 2 lifting units on the
rear axle to prevent it from moving.
To set up the lifting units, release the handbrake.
To lift, switch off the ignition of the vehicle. This prevents unexpected,
automatic control movements with active chassis.
Keep a working space of 1 m around the wheel gripper.
HydroLift
Operation
97